WCM CTX8010 Operations & Parts Manual page 18

When hydraulic oil is less than 25℃, it is needed to preheat the machine before any work; otherwise
machine may not respond or react very quickly, leading to severe accident.
Therefore it is needed to preheat machine if it is cold:
①. Adjust the manual accelerator to have engine run at medium speed, and then slowly move bucket forth and
back for 5min.
Caution: do not operate other actuators than the bucket.
②. Adjust the manual accelerator to have engine run at high speed, and then move the boom, the arm and the
bucket for 5-10min.
Caution: operations are merely limited on boom, arm and bucket, instead of any slewing or traveling.
③. Each complete action of excavator should be carried out for a few times, completing the preheating and ready
to work.
1. Excavator's Control Console
①Arm Control Lever; ②Travel control lever; ③The water temperature; ④Auxiliary Control pedal; ⑤Accelerator
lever; ⑥The Light Controller; ⑦Lever for blade;⑧The Battery Voltage; ⑨Staring Switch; ⑩Swing arm Button; ⑪
Expandable track Button
2. Traveling
Use the traveling handles.
(1) Straight
Forwards or backward move the handle, running the machine forwards or backwards.
(2) Steering
A. Left turn in situ: backward shift the left handle and meanwhile forward push the right handle.
b. Right turn in situ: backward shift right handle and meanwhile forward push the left handle.
Section III Operational essentials
17