AEG FAVORIT 40730 User Information
AEG FAVORIT 40730 User Information

AEG FAVORIT 40730 User Information

Aeg dishwasher user manual

Advertisement

FAVORIT 40730
Dishwasher
User information

Advertisement

Table of Contents
loading

Summary of Contents for AEG FAVORIT 40730

  • Page 1 FAVORIT 40730 Dishwasher User information...
  • Page 2 Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appli- ance. The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety.
  • Page 3: Table Of Contents

    Contents Operating Instructions Safety ............Diagram of appliance .
  • Page 4: Operating Instructions

    Operating Instructions 1 Safety Prior to using for the first time • Follow the ”Instructions for installation and connection”. Correct use • The dishwasher is only intended for washing domestic dishes. • Additions or modifications to the dishwasher are not permitted. •...
  • Page 5: Diagram Of Appliance

    Diagram of appliance Top Spray Nozzle Upper basket spray arm and floor spray arm Water hardness dial Dispenser for special salt Dispenser for detergent Dispenser for rinse aid Rating plate Filters Control panel ON/OFF button The ON/OFF button is used to turn the dishwasher on and off.
  • Page 6 Function buttons Function but- ton 3 Programme buttons The Programme buttons are used to select the desired dishwashing cy- cle. Function buttons: In addition to the pre-set dishwashing cycle, the following functions can also be set using these buttons: Function button 1 Function button 2 Function button 3 Programme progress display: The current stage of the programme is...
  • Page 7: Prior To Using For The First Time

    The control indicators have the following meanings: SALT RINSE AID 1) These control indicators are never illuminated while a dishwashing cycle is running. Prior to using for the first time If you wish to use 3 in 1 detergent: – First read the section “Using 3in1 detergents”. –...
  • Page 8 If indicators for the programme buttons are lit, a dishwashing cycle is activated. The cycle must be deactivated: Press function buttons 2 and 3 simultaneously for approx. 2 seconds. All additional wash programme button indicators will go out. 2. Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.
  • Page 9: Adding Special Salt

    Adding special salt To decalcify the water softener, it must be filled up with special salt. Use only special salt suitable for domestic dishwashers. If you do not use 3 in1 detergent, fill up with special salt: – Before using the dishwasher for the first time. –...
  • Page 10: Filling Up With Rinse Aid

    Filling up with rinse aid With rinse aid the rinsing water drains away better and so you get smear-free, gleaming dishes and clear glasses. If you do not use 3in1 detergent, fill up with rinse aid: – Before using the dishwasher for the first time. –...
  • Page 11: Setting The Amount Of Rinse Aid Required

    Setting the amount of rinse aid required Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfac- tory”.) The dosage can be set from 1-6.
  • Page 12: In Daily Use

    In daily use Loading cutlery and dishes Sponges, cleaning cloths and any other objects that can absorb water must not be washed in the dishwasher. Plastic and Teflon-coated dishes and pans tend to retain water droplets. These dishes and pans therefore do not dry as well as those made of china and stainless steel.
  • Page 13: Loading Cutlery

    Loading cutlery Warning: Sharp knives and other items of cutlery with sharp edges must be laid in the cutlery rack or in the upper basket to avoid the risk of injury. To ensure that all items of cutlery in the cutlery basket can be reached by the water, you should: 1.Place the grid insert on the cut- lery basket...
  • Page 14 To make it easier to load larger dish- es, the two plate rests on the right in the lower basket can be folded down. Cups, Glasses, Coffee Service Load smaller, fragile crockery and long, sharp cutlery in the upper bas- ket.
  • Page 15: Adjusting The Height Of The Upper Basket

    Adjusting the height of the upper basket with upper basket raised with upper basket lowered The height of the baskets can also be adjusted when they are loaded. Raising/lowering the upper basket 1. Pull out the upper basket complete- 2. Raise the upper basket as far as it will go and then lower it vertically.
  • Page 16: Adding Detergent

    Adding detergent Detergents remove the dirt from dishes and cutlery. The detergent must be added before the cycle starts. Only use detergent intended for do- mestic dishwashers. The detergent compartment is lo- cated on the inside of the door. 1. If the lid is closed: Press the release button.
  • Page 17: Using 3In1 Detergents

    Concentrated detergents Today’s detergents for dishwashers are almost exclusively low-alkaline concentrated detergents with natural enzymes in tablet or powder form. Using 50°C dishwashing cycles in conjunction with these concentrated detergents reduces pollution and is good for your dishes, as these dish- washing cycles are specially matched to the dirt-dissolving properties of the enzymes in concentrated detergents.
  • Page 18: Selecting The Dishwashing Cycle (Cycle Table)

    Selecting the dishwashing cycle (Cycle Table) Dishwashing- Suitable cycle for: Dinner serv- INTENSIVE ice and 70° cookware Dishes, ex- 30 MINUTES cluding (60°) saucepans Dinner serv- NORMAL ice and 50° cookware Dinner serv- ice and ENERGY cookware, SAVING 50° temperature- sensitive crockery 1) The consumption values were obtained under standardised conditions.
  • Page 19: Selecting A Programme

    Selecting a programme When your dishes look like this, select: an intensive programme. a normal or energy-saving pro- gramme. a short programme (e.g. 30 minute programme).
  • Page 20: Starting A Dishwashing Cycle

    Starting a dishwashing cycle 1. Check that the spray arms can turn freely. 2. Turn the water tap on fully. 3. Close the door. 4. Press the ON/OFF button. 5. Select the desired cycle. The programme display lights up. One or two lights will flash in the programme progress display.
  • Page 21: Setting The Delay Timer

    Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. 1. Press the ON/OFF button. 2. Press the Delay Timer button repeatedly until the indicator next to the number of hours for which the start of the dishwashing cycle is to be delayed lights up, e.
  • Page 22: Care And Cleaning

    Care and cleaning Do not use furniture care products or aggressive cleaners. • When necessary, clean the dishwasher’s controls with a soft cloth and clean warm water. • Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters The filters must be regularly checked and cleaned.
  • Page 23 5. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. 6. Re-insert the flat filter. 7. Place the fine filter in the micro-fil- ter and fit the two together. 8. Insert the filter system in place and lock it by turning the handle clock- wise as far as it will go.
  • Page 24 3. Place cleaned upper basket spray arm back in position against the connect- ing piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. 2.
  • Page 25: What To Do If

    What to do if... Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started.
  • Page 26 Malfunction the indicator for the end of the dishwashing cycle is flashing in rhythm 3 short light signals one after anoth- The cycle is not starting. Rust spots are visible in the dishwashing compartment. A whistling noise can be heard when washing dishes. Possible cause The anti-flood system has been triggered.
  • Page 27: If The Dishwashing Results Are Not Satisfactory

    If the dishwashing results are not satisfactory The dishes are still dirty. • The wrong dishwashing cycle was selected. • The dishes were loaded is such a way that the dishwashing water did not reach all items. The baskets for the dishes must not be overload- •...
  • Page 28: Disposal

    Disposal Packaging material The packaging materials are environmentally friendly and can be recy- cled. The plastic components are identified by markings, e.g. >PE<, >PS<, etc. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. Old appliance The symbol product may not be treated as household waste.
  • Page 29: Technical Data

    Technical data Capacity: Permitted water pres- sure: Electrical connection: Dishwasher: Free-standing appliances Dimensions: Max. weight: This appliance conforms with the following EU Directives: – 73/23/EEC dated 19.02.1973 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC –...
  • Page 30: Notes For Test Institutes

    Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test cycle (see “Cycle Table”). Tests in accordance with EN 50242 must be carried out when the salt dispenser in the water softener and the rinse aid dispenser have been filled with salt and rinse aid respectively, and using the test cycle (see “Cycle Table”).
  • Page 31 Lower basket with cutlery basket Cutlery basket *) If there are cup racks in place on the lefthand side or if beer glass holders are in place, remove them.
  • Page 32: Installation And Connection Instructions

    Installation and connection instructions 1 Safety information for the installation • Only transport the dishwasher in an upright position, otherwise salt water may run out. • Before using the dishwasher for the first time, check for any damage caused in transport. Do not under any circumstances connect an ap- pliance that is damaged.
  • Page 33: Installing The Dishwasher

    Installing the dishwasher • The dishwasher must be installed on a firm floor and adjusted to en- sure that it is stable and level in all directions. • To compensate for unevenness in the floor and to match the height of the appliance to that of sur- rounding units, extend the thread- ed feet using a screwdriver.
  • Page 34 Free-standing appliances If the dishwasher is installed directly next to a cooker, a heat-insulat- ing, non-flammable panel (laminated with aluminium foil on the side next to the cooker) must be fitted flush with the top edge of the work surface (depth 57.5 cm). If the appliance is built-in under a kitchen work surface, the worktop supplied with the dishwasher can be...
  • Page 35: Connecting The Dishwasher

    Connecting the dishwasher Connecting to the water supply • The dishwasher can be connected to cold and hot water supplies up to max. 60°C. • The dishwasher must not be connected to open hot water appliances or instantaneous water heaters. Permitted water pressure Lowest permitted water pressure: 1 bar (=10 N/cm2 =100 kPa)
  • Page 36: Water Drainage

    Water drainage Drain hose The drain hose must not be kinked, crushed or entangled. Connecting the drain hose: – Maximum permitted height: 1 metre. – Minimum required height: 40 cm above the bottom edge of the ap- pliance. Extension hoses •...
  • Page 37: Electrical Connection

    Water drainage into sink (only possible with free-standing appli- ances) If you wish to hang the drain hose in a wash basin, use a detachable hose elbow. You can obtain this from customer service by referring to spare part number ET 646 069 190. 1.
  • Page 38: Connecting Systems

    Connecting systems The water inlet hose, drain hose and the mains cable must all be con- nected to the side of the dishwasher as there is no space for them be- hind the appliance. 2 connection pieces 45° or straight, outer ø 19 mm, length 30 mm water- mains...
  • Page 39: Guarantee/Customer Service

    In diesen Ländern gelten die Garantiebedingungen der örtlichen Part- ner. Diese können dort eingesehen werden. Further after-sales service agencies overseas In these countries our AEG agents’ own guarantee conditions are appli- cable. Please obtain further details direct. Autres agences étrangères assurant le service après-vente Dans ces pays, les conditions de garantie des concessionnaires de la ré-...
  • Page 40 1 Chausee Street Tel.: 905 829 3980 Port Louis Fax: 905 829 3985 Tel.: 25355 Korea (South) Namibia Core Incorp. AEG NAMIBIA (PTY) 3/F Chewoo Bldg. LIMITED-Jeppe Street 200 Nonhyun-Dong Northern Industrial Area Kangnam-Ku 135-010 Windhoek Seoul Tel.: (061) 21-6082/4...
  • Page 41 Tel.: 0065 64638484 Fax: 61 1234 238 Fax: 0065 64638488 Slovakia Rep. South Africa Electrolux Slovakia S.R.O. AEG (Pty) Ltd. Seberiniho 1 55, 12th Road 821 03 Bratislava P.O. Box 1 02 64 Tel.: 02 4333 4322, 4355 Kew/Johannesburg 2000 Fax: 02 4333 6976 Tel.: 8069111...
  • Page 43: Service

    Service In the event of technical faults, please first check whether you can remedy the problem yourself with the help of the operating instruc- tions (section “What to do if…”). If you were not able to remedy the problem yourself, please contact the Customer Care Department or one of our service partners.
  • Page 44 USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 961 618-00-290305-03 Subject to change without notice...

This manual is also suitable for:

Favorit 44050 u

Table of Contents