Battery Power; Vdc Power - HIKVISION DS-PS1-E-WE Quick Start Manual

3
Power On
1.Loosen the set screw at the bottom of the sounder and remove the front panel.
Note: You can hang the front panel on the buckle.
2. Open the water-proof cover.
3. Power the sounder on.

Battery Power

1. Install four CR123A batteries according to the
polarity mark.
Note: The battries are included by default.
2. Close the water-proof cover.
3. Push the power switch to ON.
Note: For power on again, push the power swith to ON at least 5 s after power off.
CAUTION
RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE
DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS
CHEMICAL BURNING DANGER
DO NOT SWALLOW THE BATTERY
KEEP NEW AND USED BATTERIES
AWAY FROM THE CHILDREN
ON
INSTALL THE BATTERIES ACCORDING
TO THE POLARITY MARK ON THE
OFF
BATTERY HOLDER. THE OPPOSITE
POLARITY MAY CAUSE DEVICE
DAMAGE
-12V+
DO NOT REVERSE THE POLARITY OF
THE BATTERY
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China

12 VDC Power

1. Push the Cable Knock-Out away.
2. Wire the power cable.
3. Close the water-proof cover.
4. Push the power switch to ON.
Note: The 12 VDC power supply is non
EN compliant.
-12V+
2
ON
OFF
-12V+
ON
OFF
-12V+