RCA LGB126 Use And Care & Installation page 42

CONVERTING TO LP GAS
3
CONVERTING SURFACE BURNERS
1. Lift cooktop.
2. Lift burner assemblies straight up and set
aside to gain access to surface burner spuds.
Natural gas
= brass
3. With a 7mm, 5/16" or small adjustable
wrench, remove each of the four spuds on the
surface burner gas inlet tubes and replace them
with the correct gas spuds mounted in a holder
at the right rear of the range, above the
regulator. Natural gas spuds are brass and LP
gas spuds are red or silver. (Mount the spuds
that you removed from the inlet tubes back in the
holder.) To prevent leakage, make sure spuds are
securely screwed into gas inlet tubes.
4. Replace the burner assemblies.
5. Keep all spuds with your range so you have
them if you move or get a different gas hook-up.
Top Burner Orifice Drill Size
Natural Gas #54 (.0550 Dia.)
LP (Propane) #66 (.0330 Dia.)
42
or Converting Back to Natural Gas from LP
LP gas = red
or silver
OR
Color
Brass
Red or Silver
(Standard Twin Burner models only)
4
ADJUST OVEN THERMOSTAT
(for Models Equipped with Standing Pilots)
1. Remove the oven
control knob.
2. Locate the thermostat
adjustment screw at left of
thermostat shaft. Turn the
screw until the small
pointer stops at LP or N,
depending on the type of gas
you are converting to. The most
the screw will move is
1/2 a turn.
3. Replace the OVEN CONTROL knob.