heatwell TR8100VHO Instructions

LCD symbols
Symbol Event
The buttons are locked
Room temperature
ROOM TEMP
Turn on the thermostat by pressing
heat on
Program number
Manual mode
Configuration Menu
To enter into the setting menu please follow the steps below:
Step 1, Turn the thermostat off by pressing
Step 2, Press , you will then see menu 1.
MENU
Step 3, Use the up and down arrows to adjust the settings.
Step 4, Press to move to the next Menu and once y ou have all the menu options set,
NEXT
Setp 5, Press to accept and store.
DONE
Menu # Feature
Switching Differential
1
Temperature Calibration
2
Temperature Format
3
Clock Format
4
5 5+2 / 7 Day Mode
Setting the clock and day of the week
This thermostat is fitted with a real time clock. It is essenti al that the clock time and day are set accurately if you requir e your programmed events
to start on time. To set follow the steps below:
1) Touch the time display and the time will start flashing. Use the up and down arrows to set the time.By holding the arrow down the time will change faster.
NEXT
2) Press to move to the Day setting and use the u p and down arrows to get to the correct day.
3) Press DONE to store and exit.
TR8100VHO Thermos t at I nstructions
Symbol
AUTO
Override
Err
on
;
OFF
Explanation
The number of degrees difference before switching.
The default is 1°C which means the thermostat will switch
the heating on 0.5°C below the set temperature and will turn
it off 0.5°C above the set temperature.With a 2°C differential
the heating will switch on 1°C below the set temperature
and will switch off 1°C above the set temperature.
This is to recalibrate the temperature if required.
This alows the temperautre to be set to show °C or °F.
You can select the clock to show in either 12 or 24 hour time
5+2 Day mode: this mode allows you to program 5 days
(Monday to Friday) at once, then the 2 days of the weekend separately
7 Day mode : this mode allows you to program a full 7 days
at the same time or 7 days separately
See overleaf for further setting up information
Event
Automatic mode, executes the programmed schedules
Temporary temperature override
The sensor is not being read by the thermostat
Economy temperature
Comfort temperature
ver 1.0
Adjustment (press up & down buttons to adjust)
1 =1°C , 2=2°C....etc ( 1°C by default)
-1 = decrease 1 °C , 1 = increase 1 °C ...
C = °C , F = °F
24 (default), 12- hour or 24-hour clock format
1 = 5+2 day programmable
2 = 7 day programmable
Page1