heatwell TR8100V Instructions

LCD symbols

Symbol Event
The buttons are locked
Heating is turned on
Frost protection activated
Program number
Manual mode

Configuration Menu

To enter into the setting menu please follow the steps below:
Step 1, Turn the thermostat off by pressing
Step 2, Press , you will then see menu 01.
MENU
Step 3, Use the up and down arrows to adjust the sensor selecti on which is Menu 01(Air sensing;Air and Floor, or Floor only)
Step 4, Press to move to the next Menu and once y ou have all the menu options set,
NEXT
Setp 5, Press to accept and store.
DONE
Menu # Feature
Mode/Sensor selection
01
Switching Differential
02
Air Temp Calibration
03
Floor Temp Calibration
04
Temperature Readout
05
(AF mode only)
Maximum Floor Temp
06
( AF mode only)
Temperature Format
07
Clock Format
08
Frost Protection
09
5+2 / 7 Day Mode
10

Setting the clock and day of the week

This thermostat is fitted with a real time clock. It is essenti al that the clock time and day are set accurately if you requir e your programmed events
to start on time. To set follow the steps below:
1) Touch the time display and the time will start flashing. Use the up and down arrows to set the time.By holding the arrow down the time will change faster.
NEXT
2) Press to move to the Day setting and use the u p and down arrows to get to the correct day.
3) Press DONE to store and exit.
TR8100V Thermos t at I nstructions
Symbol
AUTO
Override
Err
;
POWER
Explanation
This thermostat is a combination model which allows you
to choose 3 different modes.
A mode = Air Sensing Only(Has built i n sensor)
AF mode = Air & Floor sensing( Floor probe must be installed)
F mode = Floor Sensing(Floor probe mus t be installed)
The number of degrees difference before switching.
The default is 1°C which means the thermostat will switch
the heating on 0.5°C below the set temperature and will turn
it off 0.5°C above the set temperature.With a 2°C differential
the heating will switch on 1°C below the set temperature
and will switch off 1°C above the set temperature.
This is to recalibrate the air temperature if required.
This is to recalibrate the floor temperature if required.
This gives you the option to show the Air Temperature,
Floor Temperature or to show both Air & Floor at intervals.
This is to protect the floor surface.
This alows the temperautre to be set to show °C or °F.
You can select the clock to show in either 12 or 24 hour time
This is to avoid your room temperature going below 5 °C
This allows you to program either 5 days at once, then the
2 days of the weekend separately, or a full 7 days at the
same time or 7 days separately
See overleaf for further setting up information
Event
Automatic mode, executes the programmed schedules
Temporary temperature override
The floor sensor is not being read by the thermostat
Economy temperature
Comfort temperature
ver 1.0
Adjustment (press up & down buttons to adjust)
A, AF, F
1 °C, 2°C....10°C ( 1°C by default)
-1 °C = decrease 1 °C , 1 °C = increase 1 °C ...
-1 °C = decrease 1 °C , 1 °C = increase 1 °C ...
A= to show air temperature, F=to show floor temperature,
A--F = to show both in 5 second intervals
20 °C~ 40 °C (40 °C by default)
C or F
24 (default), 12- hour or 24-hour clock format
on= activated, off= deactivated
01 = 5+2 day programmable
02 = 7 day programmable
Page1