Summary of Contents for Clare Controls CM-SP1410-HD
Page 1
HDMI 1x4 Splitter User Guide Model CM-SP1410-HD Doc ID 2014-01-457 • Rev 01...
Page 2
US and international copyright law. Trademarks and The HDMI 1x4 Splitter User Guide, Model CM-SP1410-HD name is patents a trademark of Clare Controls, Inc. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products.
In any event the total liability of Clare Controls, Inc. shall not exceed the purchase price of the product. The foregoing limitation will apply to the maximum extent permitted by applicable law, regardless of whether Clare Controls, Inc.
Introduction The CM-SP1410-HD 1x4 HDMI splitter is equipped with a high-quality one input, two output distribution chips. Its anti-static function gives it the advantage over others when distributing HDMI signals. It is equipped with HDMI 1.4a connectors. It is HDCP compliant and HDTV compatible, with a resolution up to 1920 x 1200 at 60 Hz, and 1080p.
Product appearance The CM-SP1410-HD has one HDMI input port and four HDMI output ports, as shown below. Figure 1: Front panel (1) Power switch. (2) Power indicator turns yellow when power is on. (3) Output LED indicators (four) turn yellow when the connected output devices are in a normal working state.
System connection Figure 3: System diagram Usage precautions The system should be installed in a clean environment and have proper • temperature and humidity controls. All of the power switches, plugs, sockets, and power cords should be insulated for • safety.
Application solution Figure 4: System diagram Product assortment (1) HDMI twisted pair extender 70 M maximum transmission distance over one CAT5e/CAT6 cable • Supports 1080P at 60 Hz, 48 bpp, 3D, and 4K × 2K. • Bi-directional and simultaneous RS232 and IR control •...
Page 9
(3) HDMI audio splitter/de-embedder De-embed and split the HDMI audio for two different format outputs (one video • output, one audio output) HDCP compliant and HDTV compatible • Support high-definition transmission up to 1920 × 1200 at 60 Hz resolution (max) •...
Panel drawing Figure 5: Panel drawing of the HDMI 1x4 splitter Troubleshooting and maintenance If the POWER indicator does not work, ensure the power supply is connected • properly. Check to be sure that a circuit breaker has not tripped and that power is available.
Safety operation guide To guarantee the reliable operation of the equipment and personal safety, please follow the procedures listed below. The system must be grounded properly. Do not use two blades plugs. Ensure the • supply voltage is in the correct range of 100 to 240 V and from 50 to 60 Hz. Do not locate the device in a place that is abnormally hot or cold or does not have •...
After-sales service If there appears to be problems when running the device, refer to the • “Troubleshooting and maintenance” section in this manual. Return shipping costs are not covered by this warranty. You can contact Customer Support at http://support.clarecontrols.com. Please be •...
Need help?
Do you have a question about the CM-SP1410-HD and is the answer not in the manual?
Questions and answers