Table of Contents
Advertisement
WEIGHT GROUP PARAMETERS:
Use the arrow keys to select the
"8. Installation" menu then press
the right-arrow key (only acces-
sible from the installer mode).
Use the arrow keys to select the
"2. Weigh Groups" menu then
press right-arrow key.
Use the adjustment buttons to set
the following parameters:
# of Groups:
This is the number of additional pairs of groups that are added to the basic
groups (see figure 2). Select the number of weight groups as follows:
None :
Total number of groups = 3
1 :
Total number of groups = 5
2 :
Total number of groups = 7
Group Size Mode:
Set the group size mode: % or Absolute mode. It is strongly recommend
using the relative group size (%) since this mode avoids having to change
the weight limits as the bird grow. Refer to figures 3-4.
Average group:
Select the weight range (in grams or in % depending on the chosen group
size) over which a bird is considered as being part of the average group.
Refer to figures 3-4.
Group 1:
Select the weight range (in grams or in %) above/below the average group
that defines the first additional weight group (overweight 1/ underweight 1).
Refer to figures 3-4.
This menu is only shown if at least 1 additional group has been enabled above.
Group 2:
Select the weight range (in grams or in %) above/below the oveverweight1/
underweight 1 groups that defines the second additional group (overweight 2/
underweight 2). Refer to figures 3-4.
This menu is only shown if 2 additional groups have been enabled above.
Part n° 890-00487 rev.00
8. Installation
2.
8.2 Weigh Groups
# of groups:
Group size mode:
Average group 10
Group 1
Group 2
Evolution Bird Scale Controller
Weigh groups
2
12
20
%
36
Advertisement
Table of Contents
