Assembly Instructions - Dyna-Glo DGY784BDP-D Manual

ASSEMBLY INSTRUCTIONS

1. Attach the legs.
Align one leg (A) with mounting holes on the
bottom of the smoker body (I). Thread screws
through holes from outside of unit. Nuts are
pre-welded to the cabinet. Repeat for other
3 legs (A). Tighten all screws (AA) with a
Phillips screwdriver.
Hardware Used
AA
M6x12 Screw
2. Attach the burner and control unit.
Open the bottom door of the smoker body (I).
Turn the burner and control unit (B) upside
down and place it on the bottom of the smoker
body (I), making sure the 4 mounting holes on
the burner and control unit (B) are aligned with
the holes on the smoker body (I). Note: The
control knob should be on the same side as the
door. Check that the burner is properly installed
on the orifice before attaching the burner and
control unit (B). Thread bolts (AA) through holes
from outside of unit. Securely tighten the unit
to the bottom with a Phillips screwdriver.
Hardware Used
AA
M6x12 Screw
1
x12
2
x4
8
A
AA
I
AA
B
I