Manson Engineering Industrial SBC-7100 Series User Manual page 12

Activate the feature
Please follow the steps below:
Connection
Use the RJ-45 connector (8-pin) to control ON/OFF of the LED and Equipments.
The pins configuration and connection are as follow:
Figure 10
Pin 1 & 2
Pin 7 & 4 High/Low control signal (12V, 0V) up to 0.1A, synchronized with Night Light mode
Pin 6 & 4
Pin 8 & 4
Table 7 Pins configuration
Note: Pin 3 and 5 are not used in Remote signal Terminal.
1. Open the case of the controller, there should
be a small control board near the Remote
Signal Terminal as shown in figure 6.
Figure 8
2. On the small control board, there is a sky blue
color dip switch. Turn the dip switch 1 and 2
to ON position as shown in figure 7.
Figure 9
Figure. 11 Connection diagram of RJ-45 to Equipments.
On/Off Control Signal synchronized with Night-light Mode
Shows the battery status Red LED (See Section 3.2)
Shows the battery status Green LED (See Section 3.2)
END
Rev.6 02/2012
7673-7112-0566