Magnetek DataLogger 3 Series Quick Start Manual

1. Connect to IMPULSE

The DataLogger Series 4 (DLS4) may be placed directly into the keypad
holder on the Series 4 drive. Alternatively, use the supplied Ethernet (CAT5)
cable. Plug one end into the RJ45 port on the drive and plug the other end
into the RJ45 port on the back of the DLS4.
Reference the technical manual for additional information.
2. Set the Date & Time
•
Navigate to the DataLogger Settings menu and press
•
Scroll to the Set Date/Time menu and press
•
Choose a value to change and press
•
Use the and
NOTE: To leave any menu or cancel an action, press

3. Read and Write Parameter Sets

•
Navigate to the Parameter Backup menu and press
•
To read from a drive and store a parameter set, press
•
To confirm and begin the read, press
•
To write parameters from the DLS4 to a drive, press
•
To confirm and begin the write, press

4. View Run, Fault, and Alarm History

•
Navigate to the Event History menu and press
•
Press on the desired menu and press
•
Press or
DataLogger Series 4
•G+ Mini, Series 3, or Series 4 VFD
®
. The current value will blink.
keys to choose a desired value and then press
labeled "YES".
labeled "YES".
to scroll through additional associated information.
N49 W13650 Campbell Drive
Menomonee Falls, WI 53051
Phone 262.783.3500
Toll-Free Phone 800.288.8178
Canada
Toll Free Phone: 800.792.7253
Fax: 905.8281526
.
.
.
.
labeled "READ".
labeled "WRITE".
.
or to cycle through the history log.
For service or technical
information contact:
1.866.MAG.SERV
(1.866.624.7378)
Outside the U.S. &
Canada call
1.262.783.3500, press 3
Quick Start Guide
144-27098 R1
February 2021
to accept.
www.columbusmckinnon.com/magnetek
© Copyright 2021 Magnetek