Panasonic NR-BL302 Operating Instructions Manual page 10

How to clean the refrigerator
Removing glass tray PC / FC,
glass tray crisper for cleaning
 Removing
1 . Lift the tray upward
then pulling it forward
until removing.
 Attaching
2 . Place tray on both
supporters, then
push until it reaches the end.
Remark:
 When removing tray above vegetable case,
pull out the vegetable case first and then
follow to remove the tray as above details.
 In case of attaching the tray and it does
not lock, make sure that you did not
attach the wrong tray.
 Make sure that you don't attach the upper
side of the tray downward.
 Two PC Glass trays can be used
alternatively, but Glass tray crisper should
only be attached right above crisper case.
 Removing
1 . Tilt up the pan water evap a bit and
then lift it upward until the pan water
evap hole unlocks from the pan water
evap hook.
2 . Pull the pan
water evap until
it touches with
the evap pipe
then carefully
take it out under
the evap pipe.
10
Removing pan water evap for cleaning
Removing vegetable case for cleaning
 Removing
1 . Pull the case until it
reaches the end of
stopper.
2 . Raise up the front of
case a bit and then
completely take out.
 Attaching
1 . Keep the lid on the
vegetable case
lifting until case is attached.
2 . Raise it up and place case on both
supporters.
3 . Push the case until it reaches the end.
Removing shelf egg, shelf bottle,
shelf FC for cleaning
 Removing
1 . Lift it upward,
alternating between
the right and left side.
 Attaching
2 . Place it on both supporters, and then press
until it reaches the end of supporters.
 Attaching
1 . Insert the pan water evap under the evap pipe.
2 . Insert the pan water evap hole into the hook pan
water evap as well as press-fitting both sides.
Remark: Check the status to make sure evap
pipe does not touch the pan water evap.
Hook pan
water evap
Evap pipe