Table of Contents
Advertisement
Table Stand Installation
Notes:
If the table stand has been assembled, just ignore the following instructions.
Follow the instructions accordingly based on the table stand supplied to you and
graphics shown below are for illustrative purposes only.
The TV unit and screws is subject to material object.
1. Place the TV with the display side down on a flat surface, Use a cloth to protect the display.
2. Flat base, the base will be one of the pillars placed in the end seat, make sure the screw holes
on the base and the base of the pillars aligned. Let screws into the base of the hole and tighten
the screw. In the same way to install another base pillars.
3. Install the screw holes on the back of the base and the base pillars aligned television reserved.
4. Let the four screws into the screw holes and tighten the back of the TV.
Notes:
Graphics contained within this publication are presentation only.
When the TV faced down, do not impact the screen with sharp edges to avoid
scratching the screen.
EN 19
Advertisement
Table of Contents
