Opzoon OFR-T1-S Manual

Manual
Outlook
Microphone
Power
switch
Installation Guide
1. Remove the base bracket inside the gate cover. Install the locating
adaptor on the base bracket, and then replace the base bracket to the
original position.
Locating adaptor
Base bracket
Base fixing screws
Opzoon Technology Co.,Ltd.All rights reserved.400-706-8366
2. Install the device on the locating adaptor; fasten screws after
adjusting the horizontal angle. Remove the cover from the device holder
to adjust angle, then release elevation locking screws; fasten screws
while completing angle adjustment.
OFR-T1-S
3. Install the interface module to the reserved mounting location under
the gate cover.
4. Connect cables to the interface module, and then cover the gate cover.
Positive power
Negative power
Base fixing screws
12V DC
12V DC-K1
16PIN-K1
ID card interface
Debug
global.surport@opzoon.com www.opzoon.com
Cover hole
Cover
Elevation locking
Device locating screws screws
Interface module
R_OFF
R_COM
R_ON
GND
W_OD1
W_OD0
USB-K1
port
OTG-K1
port
USB
OTG
RJ45
USB
Product Specification
Product model
OFR-T1-S
Facial anti-counterfeit Support
Recognition distance 60 ~ 90 cm
Recognition mode 1 : N , 1 : 1 , 1:1 / 1:N
Ambient light range 0 ~ 800LUX(Camera lens should be avoided from the
direct sunlight)
Processor 2.1GHz quad-cord CPU plus 192-cord GPU
Memory 2GB DDR3 RAM
Flash 16GB（scalable）
Camera
Dedicated binocular camera (visiable light and near-infarad lens)
Display 8.0" IPS LCD touch screen
Ambient temperature 0℃ ~ 45℃
Power 12V 4.16A Max
Dimenstion 148 x 123 x 351 mm (L x W x H)
WIFI Support
Bluetooth Support
Wiegand output 1，W_OD0/W_OD1/GND
Relay 1，R_ON/R_COM/R_OFF
Netword port 1
USB 2
OTG 1
Debug 1
DC 1