Samsung SPP4251 Owner's Instructions Manual page 9

Hide thumbs Also See for SPP4251:

Table of Contents

Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on

the PDP (Œ) to secure it to the wall mount bracket (´). Tighten the screws as shown

(ˇ) so that the PDP cannot be separated from wall mount bracket.

PDP panel

Wall

Wall attachment panel bracket

Connecting External Devices to the PDP

To connect external devices such as a DVD or a Home Theater System to the PDP,

please refer to following instructions:

Be sure to remove the safety pins underneath the PDP.

• If the safety pins are not removed, the angle cannot be adjusted.

Any attempt to do so may cause damage to the PDP.

Pull out the bottom of the PDP (which has been attached to the Wall Mount Bracket)

in the direction indicated by the arrows (refer to the illustration) until it clicks.

• Using the PDP After Connecting External Devices.

Be sure to secure the PDP by inserting the 2 safety pins after readjusting the

angle of the PDP to 0°.

• For safety, be sure to secure the PDP using the safety pins.

If the safety pins are not used, the PDP may fall, causing serious injury.

How to Adjust Mounting Angle

Factory default

The wall mount bracket is delivered separately. Please tighten the captive screw in the

direction of the arrow after assembling the bracket.

Changing the angle

Secure the PDP to the wall mount

bracket. (Please refer to the following

instructions.)

Set the angle by pulling the upper end of

the PDP attached to bracket in the direction

of the arrow.

The angle can be adjusted from 0° to 15°

by ±2°.

Table of Contents