Salt Indicator ( ); Rinse Aid Indicator ( ); End Of Programme; Water Cut-Off Warning - Beko BDIN38640F User Manual

the pieces being washed depending
on the step the programme you have
cancelled was in.
Salt indicator (
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
Adjusting the water hardness level is
explained in Water Softening System
section.

Rinse Aid indicator ( )

Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjusting the amount of rinse
aid
1. After switching on your machine, press
the Menu key for 3 second.
Some models require pressing Menu
key once to enter settings menu.
2. Using <- and +> keys, proceed to "P:"
on the display.
3. Set to the appropriate level with the
Selection key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash
position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
)

End of programme

When the programme you have
selected comes to an end, an audible
warning signal will warn you to turn off
your machine. This audible signal will
warn you with certain intervals before it
turns off.
End of Programme indicator will light up
when the washing programme is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the socket.
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your
dishes will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.

Water cut-off warning

If mains water is cut or water inlet tap is
turned off the machine cannot take water in
and E:02 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored E:02
icon will disappear after a while and the
washing programme resumes.

Overflowing warning

If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and E:01
icon will flash on the Programme indicator.
37/EN