Frigidaire FPBG2277RF5 Use & Care Manual page 28

CHANGING THE FILTER
Locating the Filters
Your refrigerator is equipped with water
filtering system. The water filter system filters
the water used to produce ice.
Water Filter
The water filter is located at the top right side
of the fresh food compartment.
Replacing the Water Filter
In general, you should change the water
filter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the filter after a standard amount of water
(125 gallons/473 liters for PureSource
Ultra II ) has flowed through the system.
TM
If your refrigerator has not been used for a period
of time (during moving for example), change the
filter before reinstalling the refrigerator.
Filter Cartridge
Ordering Replacement Filters
To order your replacement filters, please visit
our online store at www.frigidaire.com/store,
by calling toll-free at 1-800-599-7569, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
order extra filters when you first install your
refrigerator, and that you replace your filters at
least once every six months.
Here is the product number to request when
ordering:
PureSource Ultra II
Part #EPTWFU01

NOTE
When ordering your replacement filter,
please reorder the same filter type that is
currently in your refrigerator.
28
Water Filter
TM
PROFESSIONAL
More about your Advanced
Water Filter
The PureSource Ultra II
ice and water filter system is
tested and certified to NSF/ANSI
Standards 43, 53 and 401 for the
reduction of claims specified on
the performance data sheet.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
• Rated service flow - .65 gallons per minute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource Ultra II
water filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Turn Off the ice maker by raising the wire
signal arm.
2 Remove the old filter by rotating it counter-
clockwise (to the left) 90 degrees to release it.
3 Slide the old filter cartridge straight out of
the housing and discard it.
4 Unpackage the new filter cartridge. Slide it
into the filter housing as far as it will go with
the grip end horizontal.
5 Push lightly inward on the filter while rotating
it clockwise (to the right). The filter will then
pull itself inward as it is rotated. Rotate the
filter 90 degrees until it stops and the grip
end is vertical. You may be able to feel a very
light click as the filter locks into place.
6 Turn On ice maker.
7 To reset the water filter on your user
interface in-door control, press and hold
the water filter icon for three seconds.
When the display changes from Red to
Green, the status has been reset.
FRIGIDAIRE
TM
ice and water filter
TM
TM