Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Trace2O HydroTest HTCOD-TR
Summary of Contents for Trace2O HydroTest HTCOD-TR
- Page 1 HTCOD-TR HydroTest® COD Thermoreactor Instruction Manual...
-
Page 2: Table Of Contents
Content HTCOD-TR ..................... 3 Introduction ..................... 3 1.1.1 Preface ......................3 1.1.2 Guide to symbols..................... 3 Important information ..................4 Unpacking ....................4 Connecting ....................4 Buttons ......................6 Function of buttons ..................6 Work session ....................19 Beeper ......................19 Function schematics ................. -
Page 3: Htcod-Tr
HTCOD-TR Introduction Please read the manual before using the unit in particular taking note of the warning symbols listed below. The manufacture does not take responsibility for any issues caused by use of the unit not in accordance with the instructions laid out in this manual. 1.1.1 Preface The reactor is only suitable for 16 mm Ø... -
Page 4: Important Information
HTCOD-TR Important information Note on reactor placement The setup location must not be extremely hot, cold, humid or dusty. Heat and cold can impair the functionality of the reactor. Humidity and dust can cause the reactor to fail. Do not place the reactor near heaters such as radiators or the like. Do not expose the reactor to mechanical vibrations or jarring. -
Page 5: Unpacking
HTCOD-TR Unpacking Carefully inspect all items to ensure that every part on the list below is present and no visible damage has occurred during transportation. Store the packing material to return the unit for repair or other kinds of transport. The table below shows the parts included in the packing. -
Page 6: Buttons
Buttons Start key / Timer Heat key Heat LED Temperature key Temperature LEDs Time (interval) key Time LEDs R 125 Function of buttons Start key (for timer): By pressing this key the work cycle will start with the pre-selected values for temperature and time. At the end of the work cycle the beeper will sound (Beeper, see p. -
Page 7: Work Session
Work session This section describes the use of the reactor for a standard application. For further applications please refer to “Function schematics” (page 20). After the unit is switched on (main switch, reverse side, position I) the keypad automatically shows the last selected temperature and time span. The corresponding LEDs are lighted. - Page 8 After switching on the instrument with the main on/off switch, the heater is not active. Press the HEAT-key for heating up (status 1). After heating up to the selected temperature the timer starts after pressing START-key (status 3). Temp-/Time- next possible Status Heat-LED Temp.-LED...
-
Page 9: Maintenance
Maintenance The unit is protected by a 4AT fuse. The position of the fuse holder is on the reverse side of the unit under the main switch. Should the fuse need changing, disconnect the unit from the power supply and open the cover with a suitable tool to access the fuse. -
Page 10: Wiring Diagramm
Wiring diagramm... - Page 11 LED Error type Possible reason(s) Temp LED LED 30 min LED 60 min LED 120 min Continuous beep Frequency higher/lower Power supply frequency 50Hz / 60Hz; Mainboard faulty Safety feature reaction Mainboard faulty ADC error Mainboard faulty internal connection Wiring problem incomplete - no power;...
- Page 12 Trace2o® Limited The Technology Centre Wagtech Court Station Road Thatcham, Berkshire, RG19 4HZ Tel.: +44 (0)1635 566772 Fax: +44 (0)1635 873509 sales@Trace2o.com www.Trace2o.com...
Need help?
Do you have a question about the HydroTest HTCOD-TR and is the answer not in the manual?
Questions and answers