Extreme Networks PowerDrive Orbit Quick Operation Manual page 35

PowerDrive Orbit & X6 Quick Operations Guide - rev1.4
1100 PowerDrive X6
** This Fishing Diagram is for reference only, based on iron that has not been recut. The actual component
measurements for the tool configuration to be run in the hole should be taken by the DD on location.
*** Do not place Tongs across anchor bolt sections or on any external bias unit components. These areas are
noted NTZ (No Tong Zone) on the diagram below. When torqueing up the bit, be sure to grab above the bias
unit clamp plate assemblies.
Extreme Equipment Rentals Page 35 of 35