Timer Button; Cleaning And Maintenance - Rasonic RCF-9HL Instruction Manual

TIMER BUTTON:

Pressing the button can set automatically shutdown timer for 1 hours, 2
hours or 4 hours, and relevant indicator would light up. Timing 4h, when 2
hours has passed, the 4h indicator is off and the 2h indicator is on. After
the timing arrives, the appliance will enter the standby state.
OSCILLATION BUTTON:
Press this key to activate or deactivate horizontal oscillation of the product,
and the indicator lights up accordingly.
HEATING BUTTON:
Press this button to turn on the heater function. First press will blow low-
level heating wind, and the corresponding indicator light is on; press this
button again to blow high-level heating wind, the corresponding indicator
light is on. When the third press, heating function is turned off and the
cooling mode is returned (the wind speed remains unchanged in the middle
speed). Shut down in the heating mode, the fan needs to be delayed for 10s
before closing. Note: When the heating function is turned on, the wind
speed is fixed to the mid-level, the mid-speed wind speed indicator is on.
The timer and oscillation can work normally, press the wind speed button
can return to the cooling mode.
 Remote Control Usage:
1. Open the battery compartment on the back of remote control and then
install button batteries with 3V CR2032.
2. Please point to the receiver position during operation.
3. Pay attention to the polarity when replacing the battery.
13

Cleaning and Maintenance

 Before cleaning, repairing and maintaining, please turn off and unplug
the appliance, otherwise it might cause leakage or other machinery
damages.
 Wait until the appliance stops running before cleaning to avoid injury.
 Dust may accumulate on the rear guard and fan blade, which would
affect fan performance. Thus, we suggest that cleaning the fan at least
once every month.
 Do not use gasoline, benzene, thinner, poisonous or corrosive
detergent to clean the unit to avoid damage of the appliance.
 Surface cleaning method
-
Scrubbing the item surface with a damp cloth. Must not flush directly.
 Uninstall and cleaning method of fan blade
- According to the diagram, please unscrew (in the back of the front
cover) and turn the front cover in anti-clockwise. Take off the fan blade
cover and take fan blade out for washing.
- While reinstalling the unit, please make sure fan blade is inserted
completely, otherwise, the unit could not work properly.
14