Download Print this page

Overheat Safety Feature; Tip-Over Safety Feature - NOMA 043-6078-8 Instruction Manual

Oscillating halogen radiant heater

Advertisement

6
model no. 043-6078-8 | contact us: 1-866-827-4985
CLEANING
CAUTION - Before cleaning the heater be sure to disconnect power cord and allow the
heater to cool completely. This heater should be cleaned at least once a year to maintain
proper performance. Clean the outside surface with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners. DO NOT IMMERSE THE HEATER IN WATER. Allow heater
to dry completely before use.
REPAIR
DO NOT OPERATE THE HEATER WITHOUT ALL OF THE SAFETY FEATURES IN PLACE.
DO NOT USE THE HEATER IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY
WAY.
STORAGE
Keep original carton for storage of the heater. Store the power cord to avoid damage
during storage.

OVERHEAT SAFETY FEATURE

The heater is equipped with an automatic overheat protection device located inside the
body of the heater. If the heater grill is obstructed, or if the heater gets too hot for any
reason, the automatic overheat protection device will turn the heater off. To reset the
heater, simply turn power off and unplug the heater for 10 minutes until it cools down,
then plug the heater in and restart it. Be sure that the heater is on a smooth level surface
with no obstructions.

TIP-OVER SAFETY FEATURE

The heater is also equipped with a safety tip-over switch to turn power off to the heater
when the heater tips over. To resume heater function simply stand heater upright.
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
1.
Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
If provided, use handles when moving this heater. Keep combustible material, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3' (0.9 m) from the
front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or persons
with reduced physical, sensory, or mental capabilities and whenever the heater is left
operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Discard heater, or return
to authorized service facility for examination and/or repair.
6. Do not use outdoors.
7.
This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into a bathtub or other water
container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under furniture or appliances. Arrange cord away
from traffic areas and where it will not be tripped over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
14. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension
cord or relocatable power tap (outlet/power strip).
15. PET OWNERS NOTE: Birds and some small pets are extremely sensitive to the fumes
given off during the initial use of many appliances. Although these fumes are not
harmful to humans, it is recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing corrosion coatings burn off.
16. SAVE THESE INSTRUCTIONS.
7

Advertisement

loading