Viking VMOC205BK Service Manual page 31

7. Make sure the door is parallel with oven face lines (left
and upper side lines) and door latch heads pass through
latch holes correctly.
8. Insert the lower oven hinge into oven cavity bottom flange
and then engaged the door hinge pin. Then secure the
lower oven hinge firmly with tree (3) mounting screws.
Note: After any service to the door;
(A) Make sure that door sensing switch and secondary
interlock switch are operating properly. (Refer to
chapter "Test Procedures".).
(B) An approved microwave survey meter should be
used to assure compliance with proper microwave
radiation emission limitation standards.
DOOR ADJUSTMENT
The door can be adjusted by keeping screws of each hinge
loose.
After adjustment, make sure of the following :
1. Door latch heads smoothly catch latch hook through
latch holes and that latch head goes through center of
latch hole.
2. Deviation of door alignment from horizontal line of cavity
face plate is to be less than 1.0mm.
3. Door is positioned with its face pressed toward cavity
face plate.
4. Re-install outer case and check for microwave leakage
around door with an approved microwave survey meter.
(Refer to Microwave Measurement Procedure.)
Note: The door on a microwave oven is designed to act
as an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be
airtight, moisture (condensation)-tight or light-tight.
Remove door assembly, refer to "Door Replacement".
Replacement of door components are as follows:
1. Place door assembly on a soft cloth with latches facing
up.
Note: As the engaging part of choke cover and door panel
are provided at several places, do not force any particular
part.
2. Insert an putty knife (thickness of about 0.5mm) into the
gap between the choke cover and corner portion of door
panel as shown Figure C-6 to free engaging parts.
3. Lift up choke cover.
4. Now choke cover is free from door panel.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around
oven door is not abnormal and do not of themselves
indicate a leakage of microwave energy from oven
cavity. If such were the case, your oven could not be
equipped with a vent, the very purpose of which is to
exhaust the vapor-laden air from the oven cavity.
Figure C-5. Door Replacement and adjustment
RE-INSTALL
DOOR ASSEMBLY
LATCH
HEADS
DOOR DISASSEMBLY
1 BENT
CHOKE COVER
31
Rev 1 (May 2011)
UPPER OVEN HINGE
LOWER OVEN HINGE
RE-INSTALL
2 LIFT UP
PUTTY KNIFE
Figure C-6. Door Disassembly
Bent
Door INSIDE
Choke
Panel
cover
Upper
Lower
FRONT