Table of Contents
Advertisement
-
Swaths can also be remade later and included in earlier projects. However, then it is important
that the swaths are marked, and can be re-found, and if working with the Total station, the
same tie-in-points are used and positioned for the new swaths.
As one swath is finished, the measurement is stopped according to the MIRASoft manual, the antenna
array is moved back to the start position and a new swath is started. This is continued until the whole
investigation area is covered.
And as the measurement is finished, data processing and interpretation can be started, with the rSlicer
software. More information is found in the rSlicer operating manual.
27
Advertisement
Table of Contents
