Using Smart Diagnosis - LG F4V5VGP Series Owner's Manual

Download Cycle
Download a new and special cycle that is not
included in the basic cycles on the appliance.
Appliances that have been successfully registered
can download from a variety of specially cycles
specific to the appliance.
Only one cycle can be stored on the appliance at
a time.
Once cycle download is completed in the appliance,
the product keeps the downloaded cycle until a new
cycle is downloaded.
Standby Power Consumption
Standby power consumption
Network standby power consumption
The period of time after which the
power management function, or
a similar function, switches the
equipment automatically into standby
and/or off mode and/or the condition
providing networked standby
Open Source Software Notice
Information
To obtain the source code under GPL, LGPL, MPL,
and other open source licenses, that is contained in
this product, please visit http://opensource.lge.com.
In addition to the source code, all referred license
terms, warranty disclaimers and copyright notices
are available for download.
LG Electronics will also provide open source code
to you on CD-ROM for a charge covering the cost
of performing such distribution (such as the cost of
media, shipping, and handling) upon email request
to opensource@lge.com.
This offer is valid for a period of three years after
our last shipment of this product. This offer is valid
to anyone in receipt of this information.
32
Smart Diagnosis™ Using a Smart
Phone
• For appliances with the
Use this function if you need an accurate
diagnosis by an LG Electronics customer
information centre when the appliance
malfunctions or fails.
Smart Diagnosis™ can not be activated
unless the appliance is connected to power.
If the appliance is unable to turn on, then
troubleshooting must be done without using
Smart Diagnosis™.

Using Smart Diagnosis

0.5 W
Smart Diagnosis through the
Customer Information Centre
2.0 W
20 min.
Use this function if you need an accurate diagnosis
by an LG Electronics customer information centre
when the appliance malfunctions or fails. Use this
function only to contact the service representative,
not during the normal operation.
1
Press the Power button to turn on the
appliance. Do not press any other buttons.
2
When instructed to do so by the call centre,
place the mouthpiece of your phone close to
the Smart Diagnosis icon.
3
Press and hold the Temp. button for 3
seconds.
4
Keep the phone in place until the tone
transmission has finished. Time remaining for
data transfer is displayed.
• For best results, do not move the phone
while the tones are being transmitted.
EN
or logo