Table of Contents
Advertisement
Faults
Residual water in the dis-
penser for care product.
Compartment M is not
rinsed out completely.
Odour formation in the
washer dryer.
Status display Åis on.
Foam may come out of
the detergent drawer.
Excessive noise, vibra-
tions and "wandering"
during the spin cycle.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
The programme duration
changes during the wash
cycle.
Detergent residue on the
laundry.
Spin noise during the dry-
ing phase.
Fluff found on the washed
laundry.
Water inlet noise during
the drying phase.
Drying duration extended.
Drying programme does
not start.
Cause/Remedy
Not a fault – effect of the care product not impaired.
■
If required, remove the insert. Clean the detergent drawer and re-insert it.
■
Remove the insert. Clean the detergent drawer and reinsert it.
Run the Drum clean 90°C programme without laundry and detergent.
■
Use appropriate detergent for daily washing.
■
keep the door and detergent dispenser open after using.
■
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
■
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
■
Use commercially available low foam detergent and care products which
■
are suitable for washer dryers.
Appliance aligned? Align the appliance. ~ Page 41
■
Appliance feet fixed? Secure appliance feet. ~ Page 41
■
Transportation bolts are removed? Removing the transportation
■
bolts.~ Page 39
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call customer service. ~ Page 35
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
■
Occasionally phosphate-free detergents contain water-insoluble residue.
■
Select Rinse O or brush items when the laundry is dry.
■
This is an innovative process known as thermal spinning used to reduce
energy consumption during the drying phase.
Run the Drum Clean Ž (cold) programme without laundry and detergent to
remove fluff which have accumulated inside the drum during the previous dry-
ing cycle.
The washer dryer uses water condensation technology, water is constantly
needed to dry the laundry. Therefore the tap must be on all the time, till the end
of drying phase.
Run the Drum Clean Ž (cold) programme to remove fluff which has col-
■
lected in the washer drum during the drying phase.
Drying programme not selected? Overview of programmes ~ Page 20
■
Door not closed properly?
■
Faults and what to do about them
en
33
Advertisement
Table of Contents
