Table of Contents
Advertisement
Printouts Are Blank/Blurry or Fuzzy/Inaccurate or Bleeding Colors/
Streaks or Lines
Note
•
• If black does not print, is faint, or has a blue or red tint, refer to this web page.
Check paper and print quality settings.
Check1
Printout (Copy) Results Are Unsatisfactory
Make sure of the estimated ink levels in the FINE cartridges.
Check2
When a FINE cartridge runs out of ink, replace empty FINE cartridges with a new one.
Checking Ink Status on the LCD
Replacing a FINE Cartridge
Is the FINE cartridge installed properly?
Check3
If the FINE cartridge is not installed securely, ink may not be ejected correctly. Retract the output tray extension
and the paper output tray, open the cover, remove the FINE cartridges and then check the following.
•
• Check that there is no orange tape left on the FINE cartridge.
If the orange tape remains on the FINE cartridge, peel it off.
• Then install the FINE cartridges again. Push up the ink cartridge lock lever until it clicks into place.
•
350
Advertisement
Table of Contents
