Ramsond SUNSHIELD PRO User Manual page 9

The user can press "up" or "down" button to select the controller parameters
which need be modified. Then press "ok" to set it. When it flashes data can be
modified. After editing press "ok" again. It will stop flash. Data is saved. After
setting,press"ok"in 3 seconds or no operation in 50s,it will automatic return back
to the main page.
Items
LOAD
LOAD
LOAD
PV
PV
BAT
BAT
Note: following parameter only for battery type at DIY
BAT
BAT
BAT
BAT
BAT
Controller Operate Description
1. Battery charge after the battery type be set, SDI-P series controller
will be automatic
running, without human intervention. In special cases, the user also can
adjust parameters. The controller uses three-stage charging method provides
a fast, efficient, and safe battery charging. See the following chart Figure 5
Figure 4 Parameter Setting Initial Screen
FUN
0 Load work model
st
1 1 period time(auto mode )
2 Morning period time (auto mode)
3 Light control voltage
4 Light control delay time(minute)
5 Battery type
6 System Voltage
7 Over voltage
8 Over discharge voltage
9 Over discharge return voltage
b Boost charge voltage
F Float charge voltage
Table of Parameter Selection
parameter
9