Table of Contents
Advertisement
When this happens
The frame
cannot be
pulled out
Size of ice
cannot be
changed
Ice cube are
round, small,
joined
together
Projection
R-Y6000J_R-Y5600J (E).indd 49
Please check
Is the lever pulled down?
Was the "Large ice cube making"
button pressed?
Size of ice may not change immediately after the setting of the large ice cube making
is changed.
"Larger" size of ice may not be
made if the water level in the water
supply container is low.
Is horizontal adjustment made
properly?
Has the ice been left stored for a long time?
Has the door been opened frequently
or left open for a long time?
Is there a blackout?
Was the ice tray set with water in it?
When the water in the water supply container runs out and has just been filled, the first ice
to come out of the machine may be joined together or small.
If ices cubes are joined, separate them with the provided ice scoop.
Water passage is made on the ice tray to make ice cubes of uniform size.
This water passage makes projection at the end of ice cube.
(Continue)
Cause
Pull down the lever before pulling out the frame.
Pg. 42
It cannot be pulled out during automatic ice
making operation. To pull it out, stop ice
making and if the light is flashing, wait for
approximately 20 seconds until the light turns
off.
Pg. 31
20
Add water in the water supply container.
Pg. 28
Is horizontal adjustment is not made properly,
ice size cannot be uniform.
This is because ice was sublimated.
Ice cannot be made until the freezer
compartment is sufficiently cooled.
Ice cannot be made until the freezer
compartment is sufficiently cooled.
Make sure to empty the ice tray before setting
it in the ice maker.
Pg. 12
49
4/6/09 10:12:38 AM
Advertisement
Table of Contents
