Addendum; Memory Capacity, Size And Quality; Troubleshooting - Oregon Scientific DS6688 User Manual

ADDENDUM

MEMORY CAPACITY, SIZE AND QUALITY

The table below indicates the number of images that can be stored
when using a 16MB Secure Digital / Multi-Media card.
Approximate Number of Pictures Stored
RESOLUTION under the Following Picture Quality Selections
HIGH STANDARD
Fine (2048 x 1536) 9 16
Normal (1280 x 1024) 29 40
Basic (640 x 480) 66 105
NOTE: The above table is based on standard shooting conditions
tested by Oregon Scientific and may vary depending on the subject,
shooting conditions, capture modes, and SD card memory capacity.

TROUBLESHOOTING

PROBLEM SYMPTOM CHECK THIS
No Power Power will not Batteries are
turn on exhausted
Batteries are
inserted incorrectly.
Power turns off Battery level is
after turning on. too low
Auto Off Function
is enabled.
Taking Cannot take Camera not
Pictures pictures when turned on
Shutter Release
No space on the
Button is pressed
SD card / MMC /
internal Memory.
Mode Switch is set
to Playback mode
27
DS6688 Manual-Eng,Fre,Ger (086-003403-012)
All manuals and user guides at all-guides.com
ECONOMY
28
56
205
REMEDY
Replace with new batteries
Insert the batteries
correctly
Replace with new batteries
Disable the Auto Off
Function
Turn on the camera.
Delete unwanted files or
insert a new SD card or
MMC
Change the Mode Switch to
Camera or Movie Mode
PROBLEM SYMPTOM CHECK THIS
Flash does not Flash is set to
go off as No Flash Mode
expected.
Mode Switch is
set to Playback or
Movie Mode.
Flash has not
finished charging
Image taken Check your Flash
appears too dark Mode
or blurred.
The subject is too
far away.
The lens is dirty
Incorrect focus
mode setting
Playback Cannot play Mode Switch is
back images or not set to
movies Playback Mode
No images or
movies are
recorded
Cannot delete Images or movies
images or movies are protected
Connecting Picture not Check cable
with shown on TV connection
External when connected
Devices
Check channel on
TV.
Camera does Check the USB
not appear as cable connection.
Removable Disk
when connected
Camera or PC is
to a PC
not turned on
28
REMEDY
Enable flash by changing it
to another setting
Change the Mode Switch to
Camera Mode.
Wait until the Status Lamp
stops blinking
Turn on the flash by
changing the Flash Mode
Move closer to the subject
Clean the lens with a soft cloth
Set the dial to the correct
focus distance
Set Mode Switch to
Playback Mode.
Images located in internal
memory instead. Remove
SD card / MMC
Unprotect the images or
movies
Make sure yellow video
cable is plugged into the
TV's AV terminal
TV channel should be
switched to the
appropriate AV channel.
Turn on the camera and PC
Make sure both ends of the
USB cable are connected