General Settings; Cli Configurations - Tripp Lite NGI-M08C4-L2 Owner's Manual

capable of processing RSTP BPDUs. There is no limit to the number of MST regions in a network,
but each region can support up to 16 spanning-tree instances. You can assign a VLAN to only
one spanning-tree instance at a time.

6.14.4.1 General Settings

6.14.4.1.1 CLI Configurations

Node Command
enable show spanning-tree mst
configuration
enable show spanning-tree mst
instance
enable show spanning-tree mst
instance <0-63>
enable show spanning-tree mst
instance <0-63>interface
IFNAME
enable show spanning-tree mst
interface IFNAME
enable configure terminal
configure spanning-tree
(disable|enable)
configure spanning-tree mode mst
configure spanning-tree mst instance
STRING priority <0-
61440>
configure no spanning-tree mst
instance STRING priority
configure spanning-tree mst
configuration
configure no spanning-tree mst
configuration
mst apply
mst Instance <1-63> vlan
VLANLIST
mst name
mst no name
mst revision
mst no revision
Description
This command displays the MSTP configurations.
This command displays all of the instance
configurations of the MSTP.
This command displays specific instance
configurations of the MSTP.
This command displays specific instance
configurations on an interface of the MSTP.
This command displays the configurations on an
interface of the MSTP.
This command changes the node to configure
node.
This command enables / disables the spanning
tree.
This command configures the mode of the
spanning tree. (one of the three modes
STP/RSTP/MSTP.)
This command configures the instance name and
priority. The priority must be the multiple value of
4096.
This command resets the priority for the specific
instance. The default priority is 32768.
This command enters the MSTP configure node.
This command resets all of configurations for the
MSTP.
This command applies configurations to current
instant.
This command configures the instance and vlan
map. The target vlan number(ex.10) or
range(ex.1-10).
This command configures a region name for the
MSTP.
This command reset the region name for the
MSTP.
This command configures the revision for the
MSTP.
This command resets the revision for the MSTP.
204