Sony KS-50R200A Service Manual page 42

1. Start Download
1 Turn on power to TV, and confirm that the picture
comes out.
2 Make it standby mode with commander.
3 Pull out the AC cable, and insert Memory Stick at backside.
4 Put AC cable in.
Note: In about 1 minute of the start, the behavior
of the set is the same as normal because
of upgrading EMMA.
2. During Update
Note: The written time is a standard, if each up
grading version is the same or older, Skip
upgrading.
time
00'00": Update starts by AC ON
EMMA update starts
00'55": Go to Power ON mode
(FAN for lamp starts)
01'25": Go to Power OFF mode
03'50": TVM update starts
(Program & NVM)
05'00": WEM update starts
(Program & data)
09'30": DEM update starts
(Program & NVM)
13'50": Update end
3. After upgrading, TV-Micro REBOOT and reset all micro.
4. Confirm the end of download and pull out Memory Stick
1 After upgrading. TV reboots automatically, and confirm
that OSD appears.
2 Make it standby mode with commander and AC off.
3 Pull out Memory Stick.
4 AC On.
5. End it correctly once the update begin.
1 When there are some troubles during upgrading, do AC
cable OFF/ON with the same Memory Stick still inserted,
and try to upgrade again.
2 TV set does not work correctly when Memory Stick is
pulled out while upgrading it.
LED OSD
RED
Blinking
Same as "STBY"
GREEN
Same as "Power
ON"
Same as "STBY"
RED
Blinking DL original
ORANGE
3-6. PICTURE DISTORTION CORRECTION
MECHANISM(70R200A)
3-6-1. Preparation
<Place of correction mechanism>
V spacer
No
OSD
<How to remove the bottom cover>
Procedure:
The bottom cover comes off when the door cover on a right side of
the set is removed, and one screw in that is removed.
– 3-4 –-
KS-50R200A/60R200A/70R200A
RM-GA006 RM-GA006
The correction mechanism is
in this bottom cover.
H spacer
1 Door cover
2 Screw
RM-GA006