Advertisement
Quick Links
Advertisement
Related Manuals for Aavik acoustics P-300
Summary of Contents for Aavik acoustics P-300
- Page 1 P-300 Stereo power amplifier User’s guide...
- Page 2 P-300 Stereo power amplifier User’s guide Specifications: Contents: SPECIFICATIONS Page 2 Power output: 8Ω: 2x150W, 0.01% THD 4Ω: 2x300W, 0.01% THD SAFETY INSTRUCTIONS Page 3 FRONT PANEL FUNCTIONS Page 4 Input impedance: 11kΩ (XLR), 12kΩ (RCA) REAR PANEL FUNCTIONS Page 6...
- Page 3 Safety instructions The amplifier should be serviced by qualified service personnel 1. Read these instructions. The amplifier should be serviced by qualified service personnel when: 2. Keep these instructions. A. the power-supply cord or the plug has been damaged, or B.
- Page 4 P-300 Stereo power amplifier User’s guide Front panel STANDBY/POWER INDICATORS When the amplifier is in standby mode, the only light showing on the amplifier will be a dim LED light above the rocker button. With the amp on, the brightness of the LED increases, and the right and left sides of the display window will be diffusely lit.
- Page 5 Front panel functions The DC indicators may switch on during power up, and then switch off again after a couple of seconds. This is just the DC levels of the preamplifier or power amplifier that take a bit of time to stabilise. This causes no problems, and is not an error.
- Page 6 To connect speaker wires terminated with spades, loosen the isolation knob and insert the spade between the isolator and copper terminal. Tighten the LINE INPUTS isolation knob to secure the spade. The P-300 amplifier is equipped with an unbalanced (RCA) and a balanced Page 6...
- Page 7 Personal notes: Page 7...
- Page 8 www.aavik-acoustics.com...