Advertisement
if, during operation, power failure occurs turn the electricity and water off for safety reasons.
9
warNING! The high pressure jet will cause loose particles to be propelled at high speed, which may cause serious injury.
‰
warNING! DO NOT operate the machine without a water supply. dry running can seriously damage the unit.
‰
warNING! DO NOT leave the washer switched on for more than 15 minutes without operating the trigger.
‰
DO NOT obstruct ventilation grilles during operation.
8
DO NOT use the washer with flammable or toxic liquids or any other product. use only recommended detergent. unapproved
8
detergents may corrode the machine cover and accessories.
DO NOT jam the trigger in the operating position.
8
DO NOT adjust any internal control valves, as they have been factory set.
8
DO NOT connect other appliances to the machine inlet or outlet.
8
DO NOT move the unit by pulling the hoses or electrical cables. use the handle.
8
DO NOT touch plug with wet hands. to avoid the risk of electrocution keep all connections dry and off the ground.
8
DO NOT direct jet against yourself, other persons, animals, electrical equipment or the machine itself.
8
DO NOT use washer if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT allow children or untrained persons to operate the washer.
8
warNING! Discharge residual pressure before disconnecting the washer hose. Pressure left in unit may cause injury.
‰
After use, disconnect washer from electrical mains and water supply and store in a safe, dry, childproof area.
9
Protect from freezing conditions during winter.
9
NOTe: this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety. children should be supervised to ensure that they do not play with the appliance.
2.
INTrODuCTION
i
lightweight and powerful entry level unit, designed for domestic and light trade use. ideal for a range of applications including cleaning vehicles,
patios, decking, motorbikes and barbecues. Fitted with a powerful 1400W motor with 300 litre water flow per hour and a maximum pressure output
of 105bar. features Automatic total stop system (tss) which switches the motor on and off when the trigger is operated, prolonging motor life.
fitted with accessory storage and hose/cable hook to ensure unit stays clutter-free and mobile. Supplied with 3mtr hose, spray gun, lance and
detergent bottle. Weighs just 4.66 kg for ease of manoeuvrability.
3.
speCIFICaTION
i
Model No:...................................................pw1500/1500hV
maximum Pressure: ..................................... 105bar(1520psi)
Water flow: ...............................................................300ltr/hr
motor Power:...............................................................1400W
supply: ................................................................. 230V - 13A
total stop system: ........................................................... Yes
Hose length:...................................................................3mtr
Weight: ........................................................................ 4.66kg
effective Cleaning Power: ................................................. n/a
rotablast nozzle® ............................................................ no
nozzles: ........................................................................... null
colour ...................................................................Red/Green
4. asseMBLY
4.1.
CONNeCTING The waTer suppLY.
4.1.1.
Use a reinforced hose pipe with an internal diameter of 1/2" and connect to the mains water supply.
Before attaching the hose to the pressure washer flush the hose through with some clean water to remove any foreign matter from within
the hose.
connect ¾" BSP female fitting to inlet on the rear of the machine (Fig.1) ensuring that the filter is in place.
4.2.
CONNeCTING The hIGh pressure hOse.
4.2.1.
Attach the high pressure hose to the front of the unit as in fig.2, ensuring the connector is tight. Attach the other end to the gun (fig.3) and
tighten to ensure a leak-free joint.
4.3.
asseMBLING The LaNCe aND NOZZLe.
4.3.1.
Locate nozzle attachment into end of lance and turn 90° until it locks into place.
warNING! Ensure the nozzle is locked into position, failure to ensure this could result in the nozzle being ejected under high pressure
‰
when operating the gun.
4.4.
CONNeCTING The eLeCTrICaL suppLY.
warNING! Ensure the On/Off switch is in the 'Off' position.
‰
4.4.1.
use an rcd plugged into a 13A mains socket, DO NOT turn the power on. DO NOT touch the plug with wet hands.
fig.1
© Jack sealey limited
fig.2
Original Language Version
fig.3
PW1500, PW1500HV
Issue 1 19/12/17
Advertisement
