How To Assemble The Wall Mount Support And Display - LG LSW200B Owner's Manual

LSW400B/LSW400BG/
LSW400BX/LSW400BXG Model
Wall mount screw
<When mounting to wooden studs>
a. Locate and mark the centers of the wall studs using a stud finder.
b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and
then remove the wall bracket.
c. Use a level to make sure your screw marks are level.
d. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked
on the wall.
e. Clean the drilled hole.
f. Tighten the wall mount screws for the wall bracket on the drilled hole.
→ At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another.
(Drywall can be damaged when tightened with excessive force, please be careful.)
→ When tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench.
4

How to assemble the wall mount support and display

- Always install the display with 2 or more people.
Safety clip
Power Cord
drywall
Safety clip screw
* Assemble the wall
mount support,
product and safety
clip.
* Caution : During the locking of
LSW400B/LSW400BG/LSW400BX/
LSW400BXG models, insert the power
cord into the groove at the bottom of the
hanger bracket before locking.
(If you push in without locking inside the
groove, power cord may be in the way.)
→ If the screw cannot be assembled in the designated location
inevitably, it can be assembled by rearranging to the closest
location. But, do not change 2 or more locations from the
designated spot.
→ LSW200B/LSW200BG/LSW200BX/LSW200BXG
: Assemble the wall mount screw on 1 left and 1 right location
on the top part and 1 left and 1 right location on the bottom
part.
→ LSW400B/LSW400BG/LSW400BX/LSW400BXG
: Assemble the wall mount screw on 2 left and 2 right locations
on the top and 1 left and 1 right location on the bottom part.
→ At this time, use a "+" driver (Manual or motorized) or 8mm
wrench to tighten the screw so that the wall, wall bracket and
screw are completely pressed against one another.
76mm
wood stud
1. Set the display with the guide spacer assembled on the wall
mount bracket on the wall in arrow direction. At this time, align
the bottom assembly part and lift the set up lightly to align the
top part.
2. When adjusting the location, assemble the provide safety clip as
shown in the picture to prevent the product from moving.
Tighten the safety clip screw completely. If the safety clip is not
tightened as shown in the picture, the product can fall off.
→ Pull on the bottom of the set to make sure the display is secure.
→ When installing a display rotated, only rotate the display 90
degrees (portrait mode). (Only applies for VESA 200X200,
400x400)
→ The clearance from the wall is 14mm for this product. Make sure
to keep a certain level of distance from the wall so that excessive
force is not applied on the cable or accessory.
→ When you push the product with excessive force, the product
can be damaged.
drywall
5