Table of Contents
Advertisement
Getting to know your TV
You'll be up and running in no time
Stand installation
To complete the stand installation you will require a cross head screw driver.
3 x M(4x12)
4 x ST(4x12)
1
fig 1) Attach the stand neck to the rear of the TV set.
1
1/2
3
fig 3) Peel off the protective plastic cover then attach
the stand base to the neck.
Helpful advice for first time stand installation
When securing the self-tapping screw/s into the base of the TV (on first installation) the screw/s may be naturally
tight as they create a thread in the plastic.
a) Ensure the cross head screw driver tip fits correctly into the head of the screw and that it is not too big or small.
b) Screw in all screws individually and partially before tightening all of the screws fully.
c) If the screws become very tight try loosening and re-tightening, this will continue the process of creating
the thread.
If you still require further assistance, call one of our experts on 0345 604 0105. (Calls are charged at the standard rate of your network provider).
ALB-MAN-0006 - Alba - User Guide - 24-207O models.indd 15
ALB-MAN-0006 - Alba - User Guide - 24-207O models.indd 15
3 x
M (4x12)
2
fig 2) Secure the neck to the TV using the 3 x M (4x12)
screws provided.
4 x ST (4x12)
4
fig 4) Secure the base to the neck using the 4 x ST
(4x12) screws provided.
Getting to know your TV
15
04/12/2017 16:17:47
04/12/2017 16:17:47
Advertisement
Table of Contents
