Toro TimeCutter HD ZX4800 Operator's Manual page 35

Figure 44
1. Battery cover
4. Disconnect the negative (black) ground cable from the
battery post (Figure
Note: Retain all fasteners.
WARNING
Incorrect battery-cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
5. Slide the rubber cover up the positive (red) cable.
6. Disconnect the positive (red) cable from the battery
post (Figure 45).
Note: Retain all fasteners.
7. Remove the battery hold-down
battery from the battery tray.
2. Fasteners
45).
(Figure 45) and lift the
g190587
1. Battery
2. Negative (–) battery post
3. Bolt, washer, and nut for
the negative (–) battery
post
4. Bolt, washer, and nut for
the positive (+) battery
post
Charging the Battery
Service Interval: Before storage—Charge the battery and
1. Remove the battery from the chassis; refer to
the Battery (page
2. Charge the battery for a minimum of 1 hour at 6 to
10 A.
Note: Do not overcharge the battery.
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
1. Positive (+) battery post
2. Negative (–) battery post
35
Figure 45
5. Positive (+) battery post
6. Terminal boot
7. Battery hold-down
disconnect the battery cables.
34).
(Figure 46).
Figure 46
3. Red (+) charger lead
4. Black (–) charger lead
g188903
Removing
g000538