Table of Contents
Advertisement
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
ð on the display panel
and drying has been
interrupted.
ñ on the display panel.
SelfCleaning on the é
display panel.
Dryer does not start.
Creasing.
Water is leaking out.
Laundry is not dried cor-
rectly or is still too damp.
* depending on the model
Cause/remedy
Empty the condensate container and press the Start button ~ Page 19.
■
If the optional condensation drain* is installed, the drain hose may be
■
blocked or kinked. Check the hose for deposits and flush the hose out. Lay
the hose without any kinks.
Clean the fluff filter and press the Start button ~ Page 18.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensate container while this is displayed.
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay ~ Page 15.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table ~ Page 13.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
After the end of the programme, warm laundry feels damper than it actually
■
is. Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 15.
Select a programme with a longer drying time or increase the drying level.
■
This does not increase the temperature.
Select a timed programme for subsequent drying of laundry that is still
■
damp ~ Page 13.
If you have exceeded the maximum load for the programme, the laundry
■
may not be dried properly.
Clean the moisture sensor in the drum. A fine layer of limescale may
■
adversely affect the performance of the sensors and your washing will not
dry properly ~ Page 22.
Drying has been interrupted as a result of a power cut, because the conden-
■
sate container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips ~ Page 12.
Faults and what to do about them
en
23
Advertisement
Table of Contents
