Yamaha YTF1 Owner's/Operator's Manual page 47

1
JW6
MAINTENANCE
Transaxle Oil
To check transaxle oil level:
1. Place the utility vehicle on a flat,
level surface.
2. Raise the cargo bed.
3. Place an oil pan under the
transaxle case.
4. Clean area around servicing plug 1.
5. Using an 8 mm hex wrench,
remove transaxle oil servicing
plug located on the rear of the
transaxle case.
6. Transaxle oil should be at the top
of the oil servicing hole or just
beginning to run out of hole.
Y-1651
CAUTION
Do not allow foreign material to
enter transaxle. Serious transaxle
damage can result.
7. If needed, add SAE80 W90 API
GL-5 limited slip high perfor-
mance gear oil until it is at the
top of the plug hole or just begin-
ning to run out of servicing hole.
:
NOTE
The YTF1 utility vehicle is equipped
with an internal wet brake. Use of oil
other than SAE80 W90 API GL-5
Y-1652
limited slip high performance gear oil
will cause brake noise.
8. Install the transaxle servicing
plug and tighten to 120-168 in•lb
(14-19 Nm, 1.4-1.9 m•kg).
9. Lower the cargo bed, making
sure the latches are securely
latched.
1
2
3
4
5
6
7
8
9
10
11
8-11