Table of Contents
Advertisement
Quick Links
Item No.: TL-1525P(E1525P)
OPERATOR'S MANUAL
2.5 TON GARAGE JACK
SPECIFICATIONS
Lifting Capacity
Max. Height
Min. Height
Gross
Net
Package Size
(Ton)
(mm)
(mm)
Weight (kg)
Weight (kg)
(mm)
2.5
510
7
5
32
30.5
777X383X200
Read this manual and follow all the safety rules and operating instructions before using this product.
Advertisement
Table of Contents
Summary of Contents for Eagle Pro TL-1525P
- Page 1 Item No.: TL-1525P(E1525P) OPERATOR'S MANUAL 2.5 TON GARAGE JACK SPECIFICATIONS Lifting Capacity Max. Height Min. Height Gross Package Size (Ton) (mm) (mm) Weight (kg) Weight (kg) (mm) 30.5 777X383X200 Read this manual and follow all the safety rules and operating instructions before using this product.
-
Page 2: Warning Information
WARNING INFORMATION This is the safety alert symbol. It is used to alert you WARNING: Indicates a hazardous situation WARNING to potential personal injury hazards. Obey all safety which, if not avoided, could result in death messages that follow this symbol to avoid possible or serious injury. - Page 3 OPERATING INSTRUCTIONS Important: Sometimes during shipment and handling, air gets into the hydraulic system, causing poor lifting performance. Before initial operation, purge any air from the system by fully opening pump release valve (turn handle counter-clockwise). Then, while holding the saddle down, pump handle rapidly several times.
- Page 4 SYSTEM AIR PURGE PROCEDURE IMPORTANT: BEFORE FIRST USE Perform the following Air Purge Procedure to remove any air that may have been introduced into the hydraulic system as a result of product shipment and handling. This step is to be completed without any weight on the jack. 1.
-
Page 5: Preventative Maintenance
Raising the Jack 1. Block the vehicle’s wheels for lifting stability.Secure the load to prevent inadvertent shifting and movement. 2. Position the jack near desired lift point. 3. Set the Parking Brake in the vehicle. 4. Refer to the vehicle manufacturer owner’s manual to locate approved lifting points on the vehicle.Position the jack so that the saddle is lifting, secure and transfer load to jack stands or other appropriate means. - Page 6 Lowering the Jack 1. Raise load high enough to allow clearance for the jack stands to be removed, then carefully remove jack stands. 2. Remove support stands. 3. Grasp the handle firmly with both hands. Securely hold on to the jack handle so your hands do not slip and ensure the release valve does not rapidly lower.
- Page 7 TO REPLACE JACK OIL 5. Turn the jack on its side to drain old oil 1. Position the jack on level ground and from the oil fill hole. lower the saddle. 6.Position the jack on level ground and keep saddle in the lowered position. Fill the oil case until oil level is just beneath the lower 2.Open release valve by turning handle rim.
-
Page 8: Main Body Assembly
MAIN BODY ASSEMBLY www.eagleprojacks.net... -
Page 9: Part List
Part List Item No. Description Q'TY Item No. Description Q'TY Front Wheel Idler Wheel Retainer Ring 20 Small Handle Socket Washer 16 Washer 6 Nut M16 Nut M6x10 Real Wheel Foot Pedal Lift Arm Shaft Spring Retainer Ring 25 Rear Handle Washer 10 Locating Pin Bolt M10x25...