Related Manuals for HuTools HT02
Summary of Contents for HuTools HT02
- Page 1 PLEASE KEEP THIS GUIDE This guide contains important information about your lock. HuTools HT02 Installation Guide Customer Service: support@hutools.com...
- Page 2 Installation Guide Parts List Latch Drive-In Collar Strike Exterior Assembly Interior assembly Mounting Plate Battery Cover Exterior Assembly Mounting Battery Cover Latch and Mounting Plate Interior Screws(J) Assembly Strike Screws Latch Screws(K) Fingerprint Sensor Interior Assembly Mounting Plate Backup Key Latch/Strike Screws(I) Screws...
- Page 3 Install exterior assembly IMPORTANT: Before installation, make sure the latch is fully retracted (in the unlocked position) . Route the cable below the latch unlocked Insert the torque blade through the slot in the latch. Send the cable through the bottom horizontal slot in the mounting plate. Secure the mounting plate with the supplied screws.
-
Page 4: How To Use
How To Use UNLOCK the door from outside LOCK the door from outside Manual Mode Press any key on keypad for 2 seconds. Master/ User code Auto Re-lock Mode In Auto re-lock mode, the bolt will extend out automatically in 30 seconds UNLOCK the door with fingerprint ID after unlocking. -
Page 5: Parts Illustrations
Parts Illustrations Item Specifications Remarks Battery Last up to one year AA alkaline battery x4 (Use new, non-rechargeable (Operation voltage: 4.6~6.0V) (10 times open/close per day) Alkaline batteries only.) Exterior Assembly Interior Assembly Multi-function Button Battery Cover Keypad Fingerprint Reset Button Sensor Thumb Turn The default Master Code is 12345678. - Page 6 Quick Set Up IMPORTANT: The default Master Code is 12345678. It is recommended that you change it to a code of your own. Notes: When setting is unsuccessful, the indicator light will flash red. 5 / 6...
-
Page 7: Troubleshooting
( 12345678) . * If none of the above resolves your issue, check out our updated user manual by scanning the code below. You could also contact Hutools customer service at support@hutools.com. 6 / 6...
Need help?
Do you have a question about the HT02 and is the answer not in the manual?
Questions and answers