HP MORFB1UO User Manual page 7

User Setup
According to standard the mouse is immediately insatzbereit (receivers and mouse are
synchronized). Universe you the mouse and receiver to synchronize must, proceed you as
follows:
ID mode
If you are using more than one mouse within 6 feet of the receiver, you must set
both mice into ID Mode. Follow the instructions below to set the mouse in ID
mode.
Press and release the
2
connect button (do not
hold the button) on the
receiver. The LED on the
receiver will be
continuously on.
Push the button located on the bottom of
1
the mouse The LED on the receiver will turn
off once your mouse is synchronized. Your
mouse will now only work with that receiver.
When the mouse is in use, the LED on the
receiver will blink.
-7-