Binatone CAPRICE 500 User Manual page 11

All manuals and user guides at all-guides.com
T elephone operation continue...
During a call, the phone mutes the microphone
To mute the
or the mouthpiece so that the person on the
mouthpiece or
other end cannot hear you.
microphone
1 Press MUTE button once.
While the microphone is muted, MUTE
be shown on the lower right corner of the display.
2 Press MUTE button again to get back to the call.
MUTE
Inserting a
For some switchboard systems, an access number
Pause in the
must be dialed (usually an 8 or 9) to get another
dialing
dial tone and an outside line. Pressing REDIAL/
sequence
PAUSE button immediately after the access number,
a pause of about 3.6 secs. will be entered, and the
desired number can be dialed immediately.
Press REDIAL/PAUSE button to insert a pause when
dialing or storing Long Distance Access Codes.
RD/P
STORE
Storing a
1 In standby mode, press STORE button.
Number in a
2 Enter the telephone number, up to 22 digits.
One-Touch
The memory cannot exceed 22 digits during
memory
programming and if exceeded, the memory will
not store the number.
3 Press the desired memory location (M1, M2,
or M3) button.
Note: When the Memory buttons are full and
you wish to store a new number in memory,
follow steps 1 to 3. The new number will
replace the old number stored in memory.
Speed
1 Lift the Handset, or press SPEAKERPHONE
dialing
button on the Base unit.
2 Press the One Touch memory location M1,M2,
or M3 button.
The number dials automatically.
MUTE will MUTE MUTE MUTE
11