Table of Contents
Advertisement
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with the
equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for
emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer's label which means that the
equipment has been tested to the following Directives and Standards: This equipment has been tested to the requirements
for the CE Mark as required by EMC Directive 2014/30/ EU as indicated in European Standard EN 55032 Class B and the Low
Voltage Directive 2014/35/EU as indicated in European Standard EN 62368-1.
General Information to all Users
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to this manual
the equipment may cause interference with radio and television communications. There is, however, no guarantee that
interference will not occur in any particular installation due to site-specific factors.
1. In order to meet emission and immunity requirements, the user must observe the following:
a. Use only the provided I/O cables to connect this digital device with any computer.
b. To ensure compliance, use only the provided manufacturer's approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
2. If this equipment appears to cause interference with radio or television reception, or any other device:
a. Verify as an emission source by turning the equipment off and on. If you determine that this equipment is causing the
interference, try to correct the interference by using one or more of the following measures:
Move the digital device away from the affected receiver.
i.
Reposition (turn) the digital device with respect to the affected receiver.
ii.
iii. Reorient the affected receiver's antenna.
iv. Plug the digital device into a different AC outlet so the digital device and the receiver are on different branch
circuits.
Disconnect and remove any I/O cables that the digital device does not use. (Unterminated I/O cables are a
v.
potential source of high RF emission levels.)
vi. Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter plugs. (Removing or
cutting the line cord ground may increase RF emission levels and may also present a lethal shock hazard to the
user.)
If you need additional help, consult your dealer, manufacturer, or an experienced radio or television technician.
User Manual – Elo Mobile Computer M60/M60C
UM600609 Rev A page 88 of 94
Advertisement
Table of Contents
