Care And Maintenance; Troubleshooting - Allen + Roth WSWS-VWU1C Manual

ASSEMBLY INSTRUCTIONS
5. Set assembly upright. Insert shelf pins (EE) level
where desired in tower, then rest adjustable shelves
(E) on top.
Note: Ensure the shelf pins (EE) are level.
Hardware Used
EE Shelf Pin
6. If you intend to install the Expandable Pole (Item
#0339254, sold separately), attach wood supports (G) on
the inside of left upper side panel (B) and/or
right upper side panel (C) using wood screws (FF).
Note: The expandable pole should be installed to the
middle of wood support (G).
Hardware Used
FF Wood Screw
the wood studs. Find the center line of each stud and draw
a vertical reference line on the wall over each one. Position
installation template (K) at desired location on wall.
Note: The bottom of the installation template (K) should
Mark mounting holes with a pencil (not included) and dis-
card installation template (K). Drill 3/16 in. pilot holes at
marked locations. Then, with the beveled edge facing up,
attach the wall hanging cleats (A) with
Hardware Used
II
Lag Bolt
JJ Large Flat Washer
5
E
EE
x 8
E
EE
6
G
FF
x 8
Expandable pole kit
(sold separately)
7
Wooden Stud
A
40.6 in.
K
A
x 4
Minimum 31-1/2 in.
x 4
Lowes.com/allenandroth
6
ASSEMBLY INSTRUCTIONS
8. With the help of another person, carefully hang
the unit from mounting cleat (F) and preassembled
cleats (A).
EE

CARE AND MAINTENANCE

Periodically check to make certain all components are properly positioned, free from damage
Use a soft, clean cloth that will not scratch the surface when dusting.
G
Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
In the event the furniture is stained or otherwise damaged during use, it is recommended you
call a professional to repair the furniture.
It is best to keep the furniture in a climate-controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
Touch-up pen (LL) has been provided (except in Item
nicks or scratches that may occur during assembly or shipping. If Item
damaged and touch-up is required, apply a quality wood polish to the damaged surface. Polish
not included with this item.

TROUBLESHOOTING

PROBLEM
JJ
Closet tower tilted.
II
Closet tower can
not hang on the
JJ
wall.
II
8
#0339213,
POSSIBLE CAUSE CORRECTIVE ACTION
The wall hanging cleats are not level. Reinstall the wall hanging cleats and
ensure they are level.
The mounting hole locations are not Reinstall wall hanging cleats; make
correct. sure the space between two wall
hanging cleats is 40.6 in. and the
bottom two mounting hole locations
are no less than 31-1/2 in. from the
7
F
A
2416435) to repair any small
#0339213, 2416435 is
Lowes.com/allenandroth