Clas Ohlson CO/Tech K-NCF-LN10W Instruction Manual

LED Ceiling Light
Please read the entire instruction manual before use and
then save it for future reference. We reserve the right for any
errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
The light source of this luminaire is not replaceable: when the
light source reaches its end of life the whole luminaire shall be
replaced.
The light fitting is Class 1 rated and must therefore be
earthed.
The light source is not suitable for use with a dimmer.
Warning:
• This light fitting is only suitable for permanent installation
and should be installed by a qualified electrician.
• The light fitting should be mounted out of the reach.
• Ensure proper footing and balance at all times during
installation.
• Whenever installing any electrical products, basic
safety precautions should always be observed to avoid
the risk of fire, electric shock and personal injury.
Installation
Warning:
1. Before beginning any electrical installation
always disconnect the power to the circuit
you are working on, either by turning off
the main circuit breaker or by removing
the fuse from the consumer unit.
2. Open the end piece.
3. Remove the end
piece and take off
the plastic cover.
UNITED KINGDOM www.clasohlson.co.uk
Art.no
4. Using the light fitting as a template mark out where you
may need to drill/screw.
Warning: Make sure that the wall has no concealed
electrical wiring, gas or water pipes before drilling/
screwing. Use an appropriate fastening method for
the surface in question.
5. Make a hole in one of the silicone plugs in the end piece.
Pull the supply cable through and connect it to
the terminal block.
6. Turn the power on.
Use the same installation procedures described above to
connect several light fittings in series (36-7306-1 Max 10, and
36-7306-2 Max 5).
36-7306-1 Model K-NCF-LN10W
36-7306-2 K-NCF-LN20W
Responsible disposal
This symbol indicates that this product
should not be disposed of with general
household waste. This applies throughout
the entire EU. In order to prevent any harm to
the environment or health hazards caused by
incorrect waste disposal, the product must
be handed in for recycling so that the material
can be disposed of in a responsible manner.
When recycling the product, take it to your
local collection facility or contact the place of
purchase. They will ensure that the product is
disposed of in an environmentally sound manner.
Specifications
36-7306-1
Rated voltage
Light source
Colour temperature
Colour rendition (Ra) > 80
Luminous flux
Beam angle
IP rating
Size
36-7306-2
Rated voltage
Light source
Colour temperature
Colour rendition (Ra) > 80
Luminous flux
Beam angle
IP rating
Size
220–240 V AC, 50/60 Hz
LED 13 W
3000 K
1415 lm
110°
IP21
600 × 165 × 66 mm
220–240 V AC, 50/60 Hz
LED 24 W
3000 K
2890 lm
110°
IP21
1200 × 165 × 66 mm