Advertisement
TABLE OF CONTENTS
Safety First �������������������������������������������������������������������������������������������������������������������������������1
Installation Instructions ���������������������������������������������������������������������������������������������������������1
Operation & Maintenance �����������������������������������������������������������������������������������������������������2
Warranty ����������������������������������������������������������������������������������������������������������������������������������2
SAFETY FIRST
To ensure the safe operation and long life of your Kasco equipment, always take the following precautions:
•
Always keep people and objects clear of the de-icer propeller when operating.
•
Always disconnect the power before servicing or removing your de-icer.
•
Always operate your Kasco de-icer in the water.Operating your de-icer dry (on shore or dock) can cause
damage to the seals or injure operator.
•
Always mount your C-10 on a vertical surface and operate only with the cover closed.
•
Never lift your Kasco de-icer or C-10 control by the power cable. This could damage the power cable and
make your de-icer or control unsafe to operate.
•
Take all possible precautions around open water de-icing areas to ensure the safety of the public, such
as "Thin Ice" and/or "Open Water" signs, appropriate lighting, fencing or other safety measures as re-
quired in your area.
•
There are certain conditions under which no circulator can prevent ice damage, such as ice that moves
due to wind or current, extremely cold weather where ice forms all the way to the bottom, and in some
cases, where the bottom water temperature is the same as ice (very shallow water).
•
Effective operation can be somewhat restricted by too little bottom clearance.
INSTALLATION INSTRUCTIONS
This unit must be mounted on a vertical surface close enough to your power supply to allow at least a slight
slack in the power cord from the C-10. An 8-foot connected power cord is included.
Select the screw(s) with which to mount your C-10. You will need two for the mounting holes at the top of
the box and one for the mounting hole located at bottom of the C-10 box.
Important: Your C-10 is designed to operate only one Kasco de-icer. For the most accurate operation, avoid
placing your C-10 in direct sunlight and during the winter months, make sure it's mounted above the snow
line. Allow enough slack to prevent strain on the plug while ensuring that it is fully connected.
Note: The C-10 control must acclimate to the outdoor ambient temperature for proper operation.
Allow at least 1 hour for the C-10 to adjust to ambient temperature.
C-10 CONTROL PANEL INSTALLATION MANUAL
1
Advertisement
