Table of Contents
Advertisement
installation
1
Loading a can of product
□ Shake can vigorously for 30 seconds prior to installing can
on to foam gun.
□ Make sure the can housing is perfectly clean and apply some
Vaseline or light grease to the inside of the can housing
area. This helps prevent foam from curing to the can housing
and gluing the can on to the gun.
□ To load a can of Insulating Foam Sealant or Adhesive to a
foam dispensing gun, make sure that the threads on the can
align with the threads on the gun. Crossthreading the can
to the gun can cause the foam to dispense under the valve.
Screw the can onto the gun firmly, but do not overtighten.
danGer: Shut off all pilot lights and extinguish open
flames; eliminate all sources of ignition before use. Do not
smoke or use lighters or matches while dispensing foam.
CaUTion: The sealant and adhesive products are very
sticky and will adhere to most surfaces and skin. Do not get
foam on skin. Wear gloves, and goggles or safety glasses.
Cured foam must be mechanically removed or allowed to
wear off in time.
Foam
2
Control Bead Size With Flow Control
Knob
□ Use the flow control knob on the back of the gun to vary
bead size. Unscrewing the knob enables additional "play" in
the trigger. Bead size can be controlled.
4
Advertisement
Table of Contents
