Advertisement
NETGUARD
Setup
1. Encoding and Decoding switch setup (optional)
There is one pair of 8-position switches for netguard encoding and decoding. One is
inside the remote controller; the other is inside the receiver. The two switches can be set
to be in any positions, but the position settings of them must be the same.
2. Antenna setup
There is an antenna (a piece of green wire) inside the receiver. It is convenient to pull it
out through the hole on the side of the receiver case. With the antenna outside, the
Netguard can be operated by the remote controller for further distance. For most
applications, it is not necessary to pull the antenna outside the receiver box. Please refer
to the specifications for operation distance information.
3
Laipac Technology, Inc. |
www.laipac.com
| Tel: 1-(905)762-1228 Fax: 1-(905)763-1737
Advertisement
