Page 1
NETGUARD Netguard User Manual Introduction The Netguard is used to control the access to Internet. This manual shows how to setup and operate the Netguard. Package 1. One Netguard cable with attached Relay box and Receiver box. 2. One AC120V-DC5V adapter.
Page 2
When ON or OFF button on Remote Controller be pressed, the Remote Controller transmits encoded RF signal. The RF carrier frequency is 433.92 MHz. Remote Controller is powered by one 12V alkaline battery. Laipac Technology, Inc. | www.laipac.com | Tel: 1-(905)762-1228 Fax: 1-(905)763-1737...
Page 3
Setup 1. Encoding and Decoding switch setup (optional) There is one pair of 8-position switches for netguard encoding and decoding. One is inside the remote controller; the other is inside the receiver. The two switches can be set to be in any positions, but the position settings of them must be the same.
Page 4
Specifications • Operation Distance With the antenna inside the receiver box, the netguard can be operated by the remote controller with distance no less than 20 meters. With the antenna outside the receiver box, the operation distance is no less than 30 meters.