Shimano Non Series Dealer's Manual page 5
Lithium-ion battery
Hide thumbs
Also See for Non Series:
- Dealer's manual (56 pages) ,
- Dealer's manual (45 pages) ,
- Manual (26 pages)
Advertisement
TO ENSURE SAFETY
• Do not use the battery if leakages, discoloration, deformation or any other abnormalities
occur. If this is not observed, bursting, overheating or problems with operation may
occur.
• If any leaked fluid gets on your skin or clothes, wash it off immediately with clean water.
The leaked fluid may damage your skin.
• Do not use it outside these operating temperature ranges of the battery. If the battery is
used or stored in temperatures which are outside these ranges, fire, injury or problems
with operation may occur. The operating temperature ranges for the battery are given
below.
During discharge: -10°C - 50°C
During charging: 0°C - 45°C
• If the battery does not become fully charged after 4 hours of charging, stop charging. If
this is not observed, fire, bursting, ignition, or overheating may occur.
CAUTION
Be sure to also inform users of the following:
• Store the product in a safe place out of the reach of infants and pets.
• When you do not use the battery for a long period, charge the battery before storage.
NOTICE
Be sure to also inform users of the following:
• The connectors are small and waterproof, so do not connect and disconnect electric wires
except when necessary. Doing so may impair the waterproofing.
• Be careful not to get water into the E-TUBE ports.
• The components are designed to be fully waterproofed to withstand wet weather riding
conditions; however, do not deliberately place them into water.
• Do not clean the bicycle with a high-pressure washer. If water gets into any of the
components, operating problems or corrosion may result.
• If water collects inside the frame after riding in wet weather conditions or cleaning the
bicycle, drain the water and do not leave the battery submerged. If water gets into any
of the components, operating problems or corrosion may result.
• Handle the components carefully, and avoid subjecting them to strong shock.
• Do not use the thinners or harsh solvents to clean the products. Such solvents may
damage the surface.
5
Advertisement
